Vd-tgm0001.rar -

: Attach legs to the base (if applicable) and then the arms to the torso.

: For heavy parts (like a large cape or an outstretched arm), drill a small hole in both pieces and insert a trimmed paperclip or brass wire to act as a structural "skeleton" before gluing. 5. Gap Filling VD-TGM0001.rar

: Use fine-grit sandpaper (400 to 1000 grit) to remove support marks or "seam lines" where the mold halves met. 2. Test Fitting (Dry Fit) : Attach legs to the base (if applicable)

: If the parts were resin printed, ensure they are fully cured and washed. If they are physical resin cast parts, wash them in warm soapy water to remove mold release agents. Gap Filling : Use fine-grit sandpaper (400 to

: Extract the .rar file and compare the parts to the "Parts List" image (usually included as a JPG or PNG in the folder).

: Most VD-TGM models use a "peg and hole" system. Test each connection before applying glue.

To put this piece together effectively, follow these general assembly steps for this type of kit: 1. Preparation and Cleaning