Unit Usp 1020d Instruktsiia -

Connect a compatible 6V AC adapter into the DC port on the side of the device. ⚠️ Note: Do not use both simultaneously. 2. Setting Date and Time

Remove batteries if the device will not be used for more than 3 months. unit usp 1020d instruktsiia

In memory mode, press and hold MEM and SET simultaneously until "CL" appears on the screen. ⚠️ Error Codes & Troubleshooting Er 1 Sensor is abnormal Check cuff connection and try again. Er 2 Pulse signal not detected Ensure cuff is snug and you remain still. Er 3 Measurement result error Relax for 2 minutes and retake the test. Er 4 Cuff is too loose or leaking Re-wrap the cuff tightly. Low Battery Batteries are drained Replace all 4 batteries with fresh ones. 🧼 Maintenance & Storage Clean the monitor with a soft, dry cloth. Never submerge the cuff or monitor in water. Store in a cool, dry place away from direct sunlight. Connect a compatible 6V AC adapter into the

Sit upright in a chair with your back supported and feet flat on the floor. Cuff Placement: Place the cuff on your bare left arm. Position it about 1–2 cm (0.5 inches) above the elbow. The air tube should run down the center of your inner arm. 🩺 Taking a Measurement Press the START/STOP button. Setting Date and Time Remove batteries if the

Press the SET button while the device is off to toggle between User 1 and User 2.