: If your turntable has a separate ground wire, secure it to the GND thumb screw on the back of the PP 2 to minimize hum.
Follow these steps to correctly integrate the PP 2 into your audio system: Nad Phono Preamp Pp2 Manual
The PP 2 utilizes high-quality components and a 24V power supply for enhanced musical dynamics and stability. Moving Magnet (MM) Moving Coil (MC) Gain at 1kHz Input Sensitivity 3.5mV (ref. 200mV output) 0.2mV (ref. 200mV output) Signal-to-Noise Ratio 80dB (A-weighted) 78dB (A-weighted) RIAA Accuracy ±0.3dBplus or minus 0.3 d cap B ±0.3dBplus or minus 0.3 d cap B THD (20Hz - 20kHz) Source: NAD PP-2 Specifications . 3. Troubleshooting : If your turntable has a separate ground
The is a compact, low-noise device designed to add a turntable to modern amplifiers or receivers that only have "Line-Level" inputs (like CD, AUX, or Tuner). It supports both Moving Magnet (MM) and Moving Coil (MC) cartridges via separate inputs and a rear selector switch. 1. Setup & Installation 200mV output) 0
: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver.
Ensure the turntable's ground wire is securely attached to the PP 2 .