The most common way to flash the VST59 board is via a USB flash drive.
If you have a file named "part2.rar," it is likely half of a split archive.
: Before connecting your panel, ensure the jumper settings (3.3V, 5V, or 12V) on the board match your panel's required voltage to avoid permanent damage.
: If the image appears flipped or distorted after flashing, enter the Service Menu by pressing Menu + 1147 on the remote to adjust the Panel Config . Flashing T.VST59.031 LCD controller board firmware
: Look for a file with a .bin extension (e.g., VST59_1366x768.bin ). This is the actual firmware. 2. USB Installation Method